How To Tie A Zoo York Shoes

the drill steel

I write this post in the hope that the search engines to index correctly the title and help some poor wretch like me has to face the arduous undertaking to drill the kitchen sink.
In my case I needed to drill the button to apply the sink disposal unit, but it has the same need to mount an additional tap, such as filtered water.
So, first procuriamoci the right tools:

• A drill with the ability to adjust the speed
• A tip for metal 12mm
• A hammer
• A wrench
• The most "special" this thing:

is located at IKEA for fifteen euro, in a package along with a little "cutter" who knows, you may need in the future . I was also informed
drill hole for the steel, but between the tip and the spindle, the cost is more or less the same, and after using the "thing" I doubt that IKEA aims to produce a cup can result so perfect!

You start by creating an "invitation" to the point where we'll use it with the drill: take the bit by itself, place it in the center of the future court dates and with the hammer down a good club. Repeat the process until it forms a permanent seat for the tip to avoid that when it rotates in the drill if they go around. Do not give shots in bursts: the steel bends and the tip is likely to bounce back and change your place every time, creating a trail of microgroove instead of a nice set. Replace the tip and then with each hit.
When the groove is ready comes the hard part: the main hole. Mounted on the tip of the drill, be patient and start drilling. For a physical principle I do not know, but of which I was able to test the effects, when the steel is heated too drilling becomes more difficult. The rotation must be slow then, less than eye half the speed of a standard drill when drilling the wall. Strong push and stop the drill from time to time, for you who stand to cool the tip and steel. After fifteen minutes arrive to the fateful moment, and the drill will sink in the sink. Do not worry if the hole is blackened, gaping, torn, in short, a mess: it serves only as a guide for the "thing" Ikea, it is time to take action.
screw it around the hole, with the bolt upward and the pointed end down. When it is close to begin to turn the bolt with the key: the rotation will increase the pointed slowly cut the steel. In a remarkably short time after the initial efforts of the forum will hear a "tick" and the "thing" will be taking off within the floppy disk when you cut and leaving a nice hole on the sink, clean and precise, but be careful, very sharp!